|
|
Topic: Quick change gears
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
Page 1 of 1 of 1 replies
|
|
|
May 17, 2015 at
07:16:18 AM
|
|
Joined:
|
02/15/2015
|
Posts:
|
3
|
|
|
I have an old Halibrand quick change rearend. It came with no gears. It has a 10 spline shafts. I bought some gears and put them in it. The lower shaft is tapered and gear fits fine, but the upper shaft has no taper and gear slides and rides against bolts holding pinion gear. Someone told me there should be a spacer in there. If so where can you purchase these or should I just make one.
|
|
|
May 17, 2015 at
11:02:15 PM
|
|
Joined:
|
05/17/2015
|
Posts:
|
1
|
|
|
Reply to:
Posted By: md194709 on May 17 2015 at 07:16:18 AM
I have an old Halibrand quick change rearend. It came with no gears. It has a 10 spline shafts. I bought some gears and put them in it. The lower shaft is tapered and gear fits fine, but the upper shaft has no taper and gear slides and rides against bolts holding pinion gear. Someone told me there should be a spacer in there. If so where can you purchase these or should I just make one.
|
www.southwestspeed.com part number 604-168 hope this helps
|
|