|
|
|
|
|
Topic: Wheel question
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
|
Page 1 of 1 of 3 replies
|
|
|
|
|
October 11, 2013 at
09:34:29 PM
|
|
|
Joined:
|
08/25/2008
|
|
Posts:
|
80
|
|
|
|
I have a wheel that I got with a buyout. I cannot for the life of me figure out what brand it is nor can I find a beadlock to fit it. It is a right rear, has a Weld center in it but neither Sanders nor Weld beadlocks will fit it. If you sit the beadlock on it, you can line up the holes on one side but the opposite side hangs off the wheel by about a 1/4". Not sure if maybe its a Goudy or something? Not sure what other brands accept a Weld center but their own beadlock bolt pattern? Any help would be appreciated!
|
|
|
|
|
October 12, 2013 at
09:55:03 AM
|
|
|
Joined:
|
12/03/2004
|
|
Posts:
|
39
|
|
|
Reply to:
Posted By: CBGarage on October 11 2013 at 09:34:29 PM
I have a wheel that I got with a buyout. I cannot for the life of me figure out what brand it is nor can I find a beadlock to fit it. It is a right rear, has a Weld center in it but neither Sanders nor Weld beadlocks will fit it. If you sit the beadlock on it, you can line up the holes on one side but the opposite side hangs off the wheel by about a 1/4". Not sure if maybe its a Goudy or something? Not sure what other brands accept a Weld center but their own beadlock bolt pattern? Any help would be appreciated!
|
is it bent? measure diameter in a couple spots.
|
|
|
|
October 14, 2013 at
10:58:47 AM
|
|
|
Joined:
|
09/02/2009
|
|
Posts:
|
454
|
|
|
|
Sounds bent if some of the holes line up and others don't.....the pattern on any wheel should be consistent all the way around...
Loose is when you hit the wall with the rear of the
car, tight is when you hit the wall with the front of
the car. Horsepower is how fast you hit the wall and
torque is how far you move the wall.
|
|
|
|
|
|
|
October 14, 2013 at
04:50:17 PM
|
|
|
Joined:
|
08/25/2008
|
|
Posts:
|
80
|
|
|
|
I guess I should have been a little more clear.....I could get 2 or 3 holes to bolt up and it just got farther and farther off as you moved away from those 2 or 3. There is definitely a difference in the diameter of the wheel versus the beadlock, it's not bent.
I did however fix the problem, I just bought a Weld outer and used my Weld beadlock on it.
|
|
|
