Home | Register | Contact | Verify Email | FAQ |
Blogs | Photo Gallery | Press Release | Results | HoseheadsClassifieds.com


Welcome Guest. Already registered? Please Login

 

Forum: Sprint Car Tech Talk (go)
Moderators: BigDog


Records per page
 
Topic: 6-pin to spline Email this topic to a friend | Subscribe to this TopicReport this Topic to Moderator
Page 1 of 1   of  1 replies
FASSTER23
November 18, 2010 at 10:33:34 PM
Joined: 09/01/2010
Posts: 111
Reply

Can a 6-pin front end be converted to a spline?




Sprint_99
November 24, 2010 at 10:05:01 PM
Joined: 09/10/2009
Posts: 38
Reply

You dont want a splined front end either they are older than your 6 pin stuff. You want a direct mount setup. It depends on what type of snout your spindles have if direct mount hubs will fit. if there is nothing wrong with the 6 pin stuff just run it, there is no advantage to the direct mount setup except it is a little lighter, and most 305 cars that i know of are bolting on lead to make weight. A lot of the asphalt cars still run 6 pin stuff because its stronger.





Post Reply
You must be logged in to Post a Message.
Not a member register Here.
Already registered? Please Login





If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.

© 2024 HoseHeadForums.com Privacy Policy