|
|
Topic: Cylinder Heads FOr Sale
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
Page 1 of 1 of 1 replies
|
|
|
September 21, 2009 at
07:29:32 PM
|
|
Joined:
|
02/13/2008
|
Posts:
|
39
|
|
|
I have one set of cast iron GM cylinder heads that I am unable to use. Took them off an engine I purchased. Intake valve size is approx. 2" across the valve face. Springs are strong enough to use a roller cam, roller lifters, and roller rockers (not included). The heads look like in almost new condition. no carbon build up. Asking $400.00 or best offer. If intrested contact Lee at [email protected] or 405-625-7813. Can send pictures, casting numbers, and part numbers.
|
|
|
September 21, 2009 at
07:45:38 PM
|
|
Joined:
|
02/13/2008
|
Posts:
|
39
|
|
|
Reply to:
Posted By: Dekal Motorsports on September 21 2009 at 07:29:32 PM
I have one set of cast iron GM cylinder heads that I am unable to use. Took them off an engine I purchased. Intake valve size is approx. 2" across the valve face. Springs are strong enough to use a roller cam, roller lifters, and roller rockers (not included). The heads look like in almost new condition. no carbon build up. Asking $400.00 or best offer. If intrested contact Lee at [email protected] or 405-625-7813. Can send pictures, casting numbers, and part numbers.
|
Sorry but remeasured the intake and exaust valves seats. Intake measured around 1.94" and the exaust measured around 1.50" Would be a gread head for the Limited modifieds, modifieds, or pro stock classes.
|
|