Home | Register | Contact | Verify Email | FAQ |
Blogs | Photo Gallery | Press Release | Results | HoseheadsClassifieds.com


Welcome Guest. Already registered? Please Login

 
Blogs


Submit a New Blog
Raymond mill performance
Blog Submitted by yoyocrusher on 09/28/2017 at 3:49 AM Report Blog
  • 1. in the work process, Raymond Mill should be fixed with personnel in charge of, the operator must have a certain level of knowledge and technology, the user according to the specific conditions of factory technical training in the operation and maintenance of mill before installation and electrical and other relevant personnel must, on the machine performance to a certain degree of familiarity and Lida, can operate.
  • 2. the user unit shall make the equipment maintenance and safety system according to the use of the mill to ensure that the mill can run safely for a long time.
  • 3., in addition to the main part of the model, the main shaft adopts sliding bearings, while the other parts of the transmission adopt rolling bearings. Therefore, it must be operated in good lubrication condition, otherwise it will damage the bearing and shorten the service life. Specific refueling time and grease varieties, see lubrication system table.
  • 4.. No metal block is allowed to enter the machine, it is found to stop immediately and take out, otherwise it will damage the grinding roll and grinding ring.
  • 5., feeding should be uniform, can not be ignored. Excessive feeding will block the air duct, reduce production, easy to burn the motor, and feed too little will also reduce production. The size of the feed is shown in Table 1. No big piece of material is added to the Ultrafine Mill.
  • 6., air volume adjustment: in the fan intake pipe on the air flow control valve, generally open to the maximum position, according to fineness, yield requirements adjusted. Small air volume and high fineness. But should pay attention to, the air volume is too small, under the main engine of the wind channel easy to precipitate material, please adjust properly. The control valve on the exhaust pipe of the fan outlet is arranged at the feed inlet at the normal operation, so that no dust can be ejected.
  • 7., fineness adjustment: according to the size of the material, soft and hard, water content, the proportion of different, the processing of the thickness is also different, can adjust the analyzer above, high speed, high fineness, low speed, low fineness. Increase fineness, production will be reduced accordingly, if not meet the requirements, should debug fan air volume and speed, users can flexibly master.
  • 8. grinding roller grinding ring scrap limit, the remaining minimum wall thickness shall not be less than 10mmm.
  • 9. stop, stop feeding, host still continue to operate, so the residual materials continue to grind, about a minute later, can shut down the host motor and motor analyzer, stop grinding work, then stop the fan motor to purge residual powder.
Blog Reply
You must be logged in to Post a Reply.
Not a member. Register Here.
Already registered? Please Login




 

If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.

© 2024 HoseHeadForums.com Privacy Policy